firewood boiler convert to rice hull as fuel
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
By adding heat to boiling water, indirectly via a combustion tube and burner, as in a conventional boiler. By reducing the pressure on water stored at its saturation temperature. This results in an excess of energy in the water, which causes a proportion of the water to change into steam.Get Price
Steam boiler sight glass: this article describes how to find & use the sight glass (or sight gauge) on a steam heating boiler to check or set steam boiler water level. We explain where the sight glass will be found, how to read its water level, and the relationship between the sight glass reading and the procedure for adding make-up water to the boiler.Get Price
Whatever was left of her cargo was taken off and sold. Her engines and boiler were so badly warped and twisted from the intense heat that they were worthless except as scrap. U.S. Army Corps of Engineer dredge MARKHAM (Hull#904) was launched in 1959, at Avondale, Louisiana, by Avondale Marine Ways Inc.Get Price
Aug 05, 2018 · Steam and water cock separates the glass tube with boiler steam and water respectively. Drain cock on other hand used to drain water from glass tube. A metal ball is provided on the water side of the gauge glass to avoid subsequent accident and water loss; by water flashing off steam in event of glass rapture / failure.Get Price
Jul 04, 2008 · Additionally, one of the first things to check on a hot water boiler system when the pressure relief valve discharges water excessively is the expansion tank. If a hot water boiler expansion tank is waterlogged then you likely have a boiler pressure problem especially if the expansion tank is the steel type. More on types of expansion tanks below.Get Price
Mar 02, 2019 · The measurement of alkalinity of water is necessary to determine the amount of lime and soda needed for water softening (e.g., for corrosion control in conditioning the boiler feed water) . Alkalinity of water is mainly caused by the presence of hydroxide ions (OH − ), bicarbonate ions (HCO 3− ), and carbonate ions (CO 3 2− ), or a Get Price
Mechanisms. Carryover also known as priming is any solid, liquid or vaporous contaminant that leaves a boiler with the steam. In low/medium pressure boilers (<100 bar) entrained boiler water is the most common cause of steam contamination. Both mechanical factors such as boiler design, high water levels, load characteristics and chemical factors such as high solids …Get Price